In The News

Nanoengineering boosts carrier multiplication in quantum dots four-fold

BY NANOWERK NEWS

Wednesday, June 18, 2014

Los Alamos researchers have demonstrated an almost four-fold boost of the carrier multiplication yield with nanoengineered quantum dots. Carrier multiplication is when a single photon can excite multiple electrons. Quantum dots are novel nanostructures that can become the basis of the next generation of solar cells, capable of squeezing additional electricity out of the extra energy of blue and ultraviolet photons.

“Typical solar cells absorb a wide portion of the solar spectrum, but because of the rapid cooling of energetic (or ‘hot’) charge carriers, the extra energy of blue and ultraviolet solar photons is wasted in producing heat,” said Victor Klimov, director of the Center for Advanced Solar Photophysics (CASP) at Los Alamos National Laboratory.

Getting two for the price of one

“In principle, this lost energy can be recovered by converting it into additional photocurrent via carrier multiplication. In that case, collision of a hot carrier with a valence-band electron excites it across the energy gap,” Klimov said. “In this way, absorption of a single photon from the high-energy end of the solar spectrum produces not just one but two electron-hole pairs, which in terms of power output means getting two for the price of one.”

Carrier multiplication is inefficient in the bulk solids used in ordinary solar cells but is appreciably enhanced in ultrasmall semiconductor particles – also called quantum dots -- as was first demonstrated by LANL researchers in 2004 (Schaller & Klimov, Phys. Rev. Lett. 92, 186601, 2004). In conventional quantum dots, however, carrier multiplication is not efficient enough to boost the power output of practical devices.

A new study (“Enhanced carrier multiplication in engineered quasi-type-II quantum dots”) conducted within the Center for Advanced Solar Photophysics demonstrates that appropriately engineered core/shell nanostructures made of lead selenide and cadmium selenide (PbSe and CdSe) can increase the carrier multiplication yield four-fold over simple PbSe quantum dots.

Klimov explained, “This strong enhancement is derived primarily from the unusually slow phonon relaxation of hot holes that become trapped in high-energy states within the thick CdSe shell. The long lifetime of these energetic holes facilitates an alternative relaxation mechanism via collisions with core-localized valence band electron which leads to highly efficient carrier multiplication.”

The nuts and bolts of slowing cooling

To realize the effect of slowed carrier cooling LANL researchers have fabricated PbSe quantum dots with an especially thick CdSe shell. Qianglu Lin, a CASP student working on the synthesis of these materials said, “A striking feature of the thick-shell PbSe/CdSe quantum dots is fairly bright visible emission, from the shell, observed simultaneously with the infrared emission from the core. This shows that intraband cooling is slowed down dramatically, so that holes reside in the shell long enough to produce emission.”

“This slowed relaxation, which underlies the observed enhancement of carrier multiplication, likely relates to the interplay between core- versus shell-localization of valence-band states” explained Nikolay Makarov, a spectroscopist working on this project. Istvan Robel, another CASP member added “Our modeling indicates that when the shell is thick enough, the higher-energy hole states lay primarily in the shell, while lower-energy states still remain confined to the core. This separation leads to electronic decoupling of higher- from lower-energy holes states, which is responsible for the observed slowed cooling.”

What this could mean in future

While the present CASP work is based on PbSe/CdSe quantum dots, the concept of “carrier-multiplication engineering” through control of intraband cooling is general, and should be realizable with other combinations of materials and/or nanostructure geometries.

Jeff Pietryga, lead CASP chemist says, “Further enhancement in carrier multiplication should be possible by combining this new approach with other demonstrated means for increasing multicarrier yields, such as by using shape-control (as in nanorods) and/or materials in which cooling is already naturally slower, like PbTe.” Applied together, these strategies might provide a practical route to nanostructures exhibiting carrier multiplication performance approaching the limits imposed by energy conservation.

Source: Los Alamos National Laboratory

Read Story on Nanowerk.com

In The News

December 8, 2016
Quantum Materials Ships Quantum Dot Sample Sets
Display Daily

April 13, 2016
SID Launches Marketing Executives Forum at Display Week 2016
Society for Information Display

March 1, 2016
Quantum Materials Corp To Drive QD Production
Quantum Dots Forum

December, 2015
Vista Partners Has Initiated Coverage on Quantum Materials Corp.
VistaGlobal.com

November, 2014
Quantum Materials Scales Up Quantum Dot Production for Solar, Display and Lighting Markets
PrintedElectronicsNow.com

Friday, April 10, 2015
Quantum Dot Dark Horse
SD Torrey Hills Capital

Tuesday, February 26, 2013
A Forbes interview with Eric Drexler, renown Technologist and Author of "Radical Abundance: How a Revolution in Nanotechnology Will Change Civilization, due out in May.
Forbes.com

Thursday, October 30, 2014
Samsung, LG turn to quantum dots as OLED still too pricey
Reuters.com

Wednesday, August 20, 2014
Quantum Dot Manufacturing to get Less Expensive
Display-Central.com

Wednesday, August 20, 2014
Quantum Materials acquires patents from German company
Austin Business Journal

Friday, July 11, 2014
3D Tetrapod Quantum Dots Outperform
EE Times

Monday, June 30, 2014
Quantum Materials Corporation Secures Technology to 3D Print Quantum Dots for Anti-Counterfeiting
3dprint.com

Wednesday, June 18, 2014
Nanoengineering boosts carrier multiplication in quantum dots four-fold
Nanowerk.com

Sunday, June 1, 2014
Market Potential of Quantum Dots in the TV Display Industry
Azom.com

Tuesday, May 27, 2014
Quantum Materials plans to hire more workers for San Marcos facility
Austin Business Journal

Tuesday, April 15, 2014
Quantum Materials Now Shipping Size-Optimized Metallic Oxide Particles To Major Asian Electronics Firm
Bio News Texas

Thursday, December 12, 2013
Quantum Materials Corp. Adds Variety to Short List of Display-Oriented Quantum Dot Manufacturers in North America
Display Central

Saturday, November 16, 2013
Plugged In: San Marcos tech company bets big on tiny quantum dots
Austin-American Statesman

Thursday, October 24, 2013
Old technology enables new approaches to sustainability
Nevada Today

Thursday, October 3, 2013
Texas State University, Quantum Materials Enter Unique University-Industry Partnership to Spur Tetrapod Quantum Dot Commercialization
Bio News Texas

Wednesday, April 24, 2013
Oklahoma-based tech company relocating headquarters to Austin
Austin-American Statesman